Difference between revisions of "HDMI-Test"
From apertus wiki
(→Notes) |
|||
| Line 9: | Line 9: | ||
# Boot the Zedboard | # Boot the Zedboard | ||
# After booting is complete turn switch SW3 (fifth from the left) up | # After booting is complete turn switch SW3 (fifth from the left) up | ||
# Play around with the switches to alter the generated patterns | |||
==Notes== | ==Notes== | ||
Revision as of 17:24, 4 October 2013
- Format an SD card with one vfat partition (this is the default for the SD card that comes with the Zedboard)
- Download http://vserver.13thfloor.at/Stuff/AXIOM/ALPHA/axiom_alpha_hdmi_test_v0.1.zip and put all the files in the zipped folder onto your SD card (not into a subfolder)
- Connect a monitor to the Zedboards HDMI port and turn on the monitor.
- Shift all switches on the Zedboard down
- Boot the Zedboard
- After booting is complete turn switch SW3 (fifth from the left) up
- Play around with the switches to alter the generated patterns
Notes
If the Zedboard is booting via TFTP by default use an UART / serial console and interrupt the bootloader then type:
env default -f saveenv reset
The last command will reboot the Zedboard - alternatively you can also push the right pink pushbutton on the Zedboard.