00-SUSB-001- AXIOM Beta 1 x USB 3.0 Plugin Module V0.2 R1.0 Top Populated Show sm.jpg

Full size image

With the USB 3.0 plugin module, any computer with USB 3.0 connectivity can be used as an AXIOM Recorder to store and define the format/container/metadata/etc. of uncompressed raw 4k footage. A single module provides users with around 400MB/S bandwidth (3.2Gbit/s) - enough to record uncompressed 4096x2160 raw 12 bit video at 25 FPS. In theory, this can be doubled by utilising two of the AXIOM Beta Main Board's module slots. Software is in development and tests have showed the data exchange between camera and a connected PC over USB 3.0 is working well.

The USB3 Plugin Module incorporates an FTDI FT601 IC which acts as a multi channel 32-bit FIFO interface. With the FTDI FT602 general I/O and UVC playback is possible.

ABCS-SUSB3-02a AXIOM Beta 1 x USB 3.0 Plugin Module V0.2 R1.0 Top Populated sm.jpg

Full size image

ABCS-SUSB3-02b AXIOM Beta 1 x USB 3.0 Plugin Module V0.2 R1.0 Bottom Populated sm.jpg

Full size image

1 Development Notes

Development Status: PCB has been populated. Software in development.

The USB3 interface chip is an FTDI FT601 (https://www.ftdichip.com/Products/ICs/FT600.html) and acts as a multi channel 32-bit FIFO interface. It should also be possible to use the FTDI FT602 (https://www.ftdichip.com/Products/ICs/FT602.html) which will allow for viewing captured imaging data via standard UVC enabled hardware and commonly used media player platforms e.g. VLC Player etc.

FTDI works out of the box and can be programmed/configured via USB if necessary.

The Lattice MachXO FPGA needs to be programmed through the Beta - the JTAG interface (as well as control signals) of the Lattice MachXO FPGA on the USB3 plugin are connected to the IO pins of the plugin module slot. A little trick is required for utilizing this:

  1. A special MachXO2 bitstream is loaded which basically passes through a bunch of signals between the Plugin IO pins and the PIC microcontroller
  2. A special PIC firmware is used which does basically the same as the original one, but with slightly different pins (i.e. those connected to MachXO GPIOs not the JTAG interface). This way the normal scripts (pic_jtag_* scripts) which usually program the MachXO2 on the camera's Main Board, now generate signals which get relayed to the plugin IOs.

2 Current Revision


3 Revision Archive

PCB Top unpopulated