Difference between revisions of "Raw processing recorder benchmarking"
From apertus wiki
(Created page with "==required footage== Alex can analyze the footage recorded by the 3rd party recorder and needs the following: # short HDMI captured clip from the 3rd party recorder # raw12 s...") |
|||
| Line 2: | Line 2: | ||
Alex can analyze the footage recorded by the 3rd party recorder and needs the following: | Alex can analyze the footage recorded by the 3rd party recorder and needs the following: | ||
* short HDMI captured clip from the 3rd party recorder | |||
* raw12 still image captured during the HDMI recording (its important that the framing is 100% identical so be sure to shoot this from a steady tripod and that operating the recorder does not move the camera the slightest - if there is a 1 pixel offset due to camera motion the test will not generate proper results). | |||
# HDMI captured 1-minute clip with dark frames (lens cap on camera, black cloth covering camera in a completely dark room - its very important that absolutely no photon hits the sensor surface) | |||
This kind of script is helpful to execute during HDMIrecording: | |||
#stop HDMI stream: | |||
fil_reg 15 0 | |||
#capture image | |||
./cmv_snap3 -r -2 -e 10ms > image.raw12 | |||
#start HDMI stream: | |||
fil_reg 15 0x01000100 | |||
* HDMI captured 1-minute clip with dark frames (lens cap on camera, black cloth covering camera in a completely dark room - its very important that absolutely no photon hits the sensor surface) | |||
Revision as of 17:42, 2 May 2016
required footage
Alex can analyze the footage recorded by the 3rd party recorder and needs the following:
- short HDMI captured clip from the 3rd party recorder
- raw12 still image captured during the HDMI recording (its important that the framing is 100% identical so be sure to shoot this from a steady tripod and that operating the recorder does not move the camera the slightest - if there is a 1 pixel offset due to camera motion the test will not generate proper results).
This kind of script is helpful to execute during HDMIrecording:
#stop HDMI stream: fil_reg 15 0
#capture image ./cmv_snap3 -r -2 -e 10ms > image.raw12
#start HDMI stream: fil_reg 15 0x01000100
- HDMI captured 1-minute clip with dark frames (lens cap on camera, black cloth covering camera in a completely dark room - its very important that absolutely no photon hits the sensor surface)