Difference between revisions of "Stereo 3D Requirements"
From apertus wiki
(Created page with "* synchronous sensor trigger (genlock, trigger master-slave) * synchronous camera parameters (shutter, whitebalance, etc.) * sensor position finetuning (backfocus, top/bottom ...") |
(No difference)
|
Revision as of 11:54, 19 November 2013
- synchronous sensor trigger (genlock, trigger master-slave)
- synchronous camera parameters (shutter, whitebalance, etc.)
- sensor position finetuning (backfocus, top/bottom & left/right shift in sub mm area), roll & tilt compensation is not required
- SDI output so the signals from both cameras can be converted into something 3d monitors can display with a device like this: http://www.aja.com/en/products/mini-converters/hi5-3d
Sensor diameter
The industry is still split between declaring DOF good or bad as esthetically element for S3D. In general a 2/3" sensor diameter is considered the standard for reduced DOF Stereo 3D recording.